Kraus KPF-1630 User Manual

INSTALLATION MANUALwww.kraususa.com I toll free: 1.800.775.0703 I © 2013-2014 Kraus USA Inc.Single Lever Pull-Down Kitchen FaucetKPF-1630

Connect waterlines (not included) to hot and cold copper lines (8). Connect waterlines (not included) to angle stops. Tighten both ends of waterlines

Care & Maintenance*To keep the product clean & shining, follow the steps below:1. Rinse with clean water & dry with a soft cloth2. Do no

Trouble - Shooting If you have followed the instructions carefully and your faucet still does not work properly, take the following corrective step

Step 1: Remove button located at the top of the handle. Loosen the set screw with a hex wrench. Remove the handle and unscrew cartridge cover by hand

Codes/Standards Applicable:KRAUS LIMITED LIFETIME WARRANTYThis product has been manufactured and tested to the highest quality standards by Kraus USA

C. Kraus recommends installing all Kraus products with a licensed, professional plumber. Kraus will not be held responsible for any damage or product

www.kraususa.com

Thank you for your purchaseWe would like to take this opportunity to thank you for choosing Kraus. We hope that you are completely satised with your

Prior to Installation:• Make sure you have all necessary parts by checking the diagram and parts list. If any part is missing or damaged, please cont

Diagram and Parts List1911104A3A78A256128B3B4B4C

Diagram and Parts ListTools you will need11027910 31/32”Minimum distance 90mmLess than 90mmCold Water32 3/32”Ø35~Ø38123109111213Hexagon NutHotWaterCol

Faucet Installation Procedure Installer Tip:Shut o main water supply before installing new faucet9.2”(233.8mm)6.7”(170.5mm)2.87”(73mm)9.3”(236mm)5.35

Step 1: Remove mounting hardwareRemove the mounting screws (4C), mounting nut (4B), and rubber & metal washer (4A) from the mounting pipe Step 2A:

For single-hole installation: Deck plate (3A), base plate (3B), and silicone sealant are NOT requiredStep 3: Install faucet and mounting hardwareInser

Step 4: Secure mounting hardwareAdjust direction of faucet body (2) so that handle is on right side of faucet. Tighten mounting nut (4B) until snug. T